XD-79A Angle sensor

ماژول تشخیص زاویه XD-79A مناسب جهت طراحی رباتXD-79A factory direct 2-way switch dump angle sensor module angle sensor moduleusing the companys SW-520D tilt sensor sensitivitythe comparator output signal is clean, good waveform, driving ability, more than 15mAadjust the sensitivity distribution positionthe working voltage 3.3V-12V(5. output format: digital switching outputs (0 and 1a fixed bolt holes, easy installationa small PCB board size: 3.2cm x 1.7cmusing a wide voltage LM393 comparator:Module for useThe initial state of a two-way output from the tilt sensor depends on the conduction and off , when turned on , the green light , the output low , the tilt sensor is disconnected , the green light is off , output is highAverage tilt sensor are installed in an initial state in a normally open state , the inclination sensor is not in operation , extend the service lifeDefault SW-520D sensor for detecting objects dumped 90 degrees , for other angles , please consult the treasurerthe output can be directly connected to the microcontroller through the microcontroller to detect high and low , thereby detecting the angle of environmental changethe output of the relay module can directly drive the shop , which can be composed of a high- angle control switch