RF4432-A module

Ultra-thin ultra-small (16.5 × 17mm)Using the latest version of the U.S. SI4432 ICFrequency range: 433.92MSensitivity up to-121dBmDdata transfer rate:0.123-256kbpsFSK, GFSK and OOK modulationPower supply: 1.8-3.6 VThe module is based on SI4432 from Silicon labs.The -121dBm and +20dBm output power ensures extended range,make the module suitable for long range applications.Its communication distance up to 1500m.User can modify the internal parameters through the SPI interface.The Module is with a nickel-plated shield cover to enhance anti-interference ability greatly. Ultra-thin ultra-small (16.5 × 17mm) Good harmonics The penetration ability (measured through 4-6 floors) Using the latest version of the U.S. SI4432 IC, stable performance Frequency range: 433.92M Sensitivity up to-121dBm Maximum output power: 20dBm Ddata transfer rate:0.123-256kbps FSK, GFSK and OOK modulation Power supply: 1.8-3.6 V Ultra-low-consumption shutdown mode Digital received signal strength indication (RSSI) Wake time Automatic matching and two-way antenna switch control Configurable packet structure Preamble detection 64-byte send and receive data register (FIFO) Low power detection 8-bit ADC and temperature sensor Operating temperature range: -20 ~ +60 ° C Integrated voltage regulator Frequency hopping Power-on reset function Built-in lens adjustment Pin No. Pin Definition Description 1 GND Ground 2 GPIO0 Transmit control pin in internal connected module 3 GPIO1 Receive control pin in internal connected module 4 GPIO2 Connect the GPIO2 pin of the chip 5 VCC Power supply: +3.3V 6 SDO 0–VDD V digital output that provides a serial readback function of the internal control registers 7 SDI Serial Data input. 0–VDD V digital input. This pin provides the serial data stream for the 4-line serial data bus. 8 SCLK Serial Clock input.0–VDD V digital input.This pin provides the serial data clock function for the 4-line serial data bus. Data is clocked into the Si4430/31/32 on positive edge transitions.  9 nSel Serial Interface Select input. 0– VDD V digital input.This pin provides the Select/Enable function for the 4-line serial data bus. The signal is also used to signify burst read/write mode. 10 nIRQ General Microcontroller Interrupt Status output 11 SDN Shutdown input pin.0–VDD V digital input.SDN should be = 0 in all modes except Shutdown mode.When SDN =1 the chip will be completely shutdown and the contents of the registers will be lost. 12 GND Ground 13 ANT Extra antenna or TR switch control to be used if more GPIO are required. Pin is a hardwired version of GPIO setting 11000, Antenna 2 and can be manually controlled by the antdiv[2:0] bits in register 08h. 14 GND Ground