CP2102 module USB to TTL with OTG socket

CP2102 Micro USB to UART TTL Module 6Pin Serial Converter STC Replace FT232Features:1, Use original chip CP2102, generate COM port after installing the driver.2, The standard input MICRO MINI-USB cable connected to the computer USB interface, with 3.3V and 5V two power output3, With a resettable fuse. In the event of accidental short-circuit can effectively protect your device and computer USB port to download4, On-board status indicators, receiving indicator properly installed drive status indicator remains, send and receive indicator flashes when the communication with run LED indicator.5, Supports baud rates from 300bps ~ 1Mbps between6, The communication format support: (1) data bits 5, 6, 7, 8. (2) support 1.5, 2 stop bits. (3) odd, even, mark, space, none parity7, Supported operating systems: windows 8.1 / 7 / vista / XP / 98, Mac OS-X / OS-9, Linux8, USB seat MICRO MINI-USB interface block9, With DTR trigger signal output can be directly arduino pro mini ATMEGA328P and other Arduino board download traffic.10, Module size: 15.7mm * 21.2mm super small.Specifications:1. Embedded USB transceiver, no external circuit device2. Containing clock circuit, no external circuit device3. Contains power-on reset circuit The on-chip voltage regulator within the 3.3V output5. Meet the USB2.0 specification requirements6. SUSPEND pins support USB suspend state7. Asynchronous serial data bus compatible with all handshakes and modulation controller interface signals8. Support data format is 8 data bits, 1 stop bit and the parity bit9. Connotation 512 byte receive buffer and 512 byte transmit buffer10. Supports hardware or X-ON / X-OFF HandshakeHow to install the driver:WIN7 / WIN81. first open the package, like the way next, remember installation directory2. according to the following method to start the service3. Locate the driver in Device Manager, select Update Driver, browse my computer for driver,select the directory just installed, determine waiting likeWIN8.1Right update drivers automatically find the drivers, it will prompt the driving data is invalid, in fact, the problem often encountered in windows8, the drive is no problem, the beginning has been installed on, and later discovered may be a hardware incompatibility.If you are using Windows8 or windows 8.1, but is non-genuine ghost or other systems, and uses a variety of optimization tools Streamlining system, then in the process of installing the driver, you may encounter the Data invalid wrongInvalid Data solutions are as follows:1, press Winkey + R on the keyboard, the pop-up Run dialog, enter services.msc,also by under Computer Management window, find the service;2, found in the list of services Device Install Service and Device Setup Manager two service items,make sure these two services is turned on, if not open, you can click the left side of the Start service.Driver Download: http://www.silabs.com/products/microcontroller/downloads.aspPackage Included:1 x CP2102 Module