AT056TN52 v.3 With 4-Wire Touch Screen

  General Specifications:1 LCD size 5.6 inch(Diagonal)2 Driver element a-Si TFT active matrix3 Resolution 640 × (RGB) × 4804 Display mode Normally White, Transmissive5 Dot pitch 0.0588(W) × 0.1764(H) mm6 Active area 112.896 (W) × 84.672(H) mm7 Module size 126.5(W) × 100(H) × 5.7(D) mm Note 18 Surface treatment Anti-Glare9 Color arrangement RGB-stripe10 Interface Digital11 Backlight Power consumption 0.930W12 Panel Power consumption 117mW13 Weight 132gPin Assignment:TFT LCD Panel Driving SectionFPC connector is used for the module electronics interface. The recommended model is FH12S-50S-0.5SH manufactured by HiRose.Pin No. Symbol I/O Function1 VLED+ P Power for LED backlight anode2 VLED+ P Power for LED backlight anode3 VLED- P Power for LED backlight cathode4 VLED- P Power for LED backlight cathode5 GND P Power ground6 VCOM I VCOM input7 VCC P Digital power supply(+3.3V)8 MODE I DE or HV mode control9 DE I Data Enable10 VS I Vsync signal input11 HS I Hsync signal input12 B7 I Blue data input (MSB)13 B6 I Blue data input14 B5 I Blue data input15 B4 I Blue data input16 B3 I Blue data input17 B2 I Blue data input18 B1 I Blue data input19 B0 I Blue data input (LSB)20 G7 I Green data input (MSB)21 G6 I Green data input22 G5 I Green data input23 G4 I Green data input24 G3 I Green data input25 G2 I Green data input26 G1 I Green data input27 G0 I Green data input(LSB)28 R7 I Red data input(MSB)29 R6 I Red data input30 R5 I Red data input31 R4 I Red data input32 R3 I Red data input33 R2 I Red data input34 R1 I Red data input35 R0 I Red data input(LSB)36 GND P Power ground37 DCLK I Sample clock38 GND P Power ground39 L/R I Select left to right scanning direction40 U/D I Select up or down scanning direction41 VGH I Positive power for scan driver42 VGL I Negative power for scan driver43 AVDD P Power supply for analog circuit44 RESET I Reset45 POL O Polarity select for the line inversion control signal46 VCOM I VCOM input47 NC – No Connector48 NC – No Connector49 NC – No Connector50 NC – No Connector Note: I: input, O: output, P: Power, R: Reserve